Helpful Tips for Installing Cabinet Knobs and Pulls

So you have some brand new cabinet knobs or cabinet pulls that will go great with the new look you've chosen for your kitchen. Now you're faced with the task of installing them. Don't let this intimidate you! You do want to take your time and be extra careful, but it's not as hard as it sounds.

You either have brand new cabinets and drawers that have never had holes drilled into them before, or you've filled in the holes in your old cabinets and made them fresh for an all new knob installation. This is an important first step, because you don't want any old holes visible.

Things You Will Need

Make sure you have all of your supplies together before you get started:

A tape measure, Sticky tack, A drill, Drill bits the same size as the screws you're using, A piece of cardboard, A pencil.

Decide on Placement

Placement of the knobs or pulls is important, because being able to grab them and open the cabinets or drawers comfortably and easily is 100% of their function. Not only will you need to be able to grab and open them easily, but so will everyone else in the house.

Centered isn't always best – it really depends on the nature of the cabinet doors and drawers themselves. You can test the positioning of the knobs or pulls by putting some sticky tack (it won't damage the surface of the cabinets) on the hardware where they would be touching the cabinet, and stick them on. Try out a few positions until the look and feel right on each cabinet.

Laurey Mission Bay Pull in Antique Pewter

Make a Template

Once you have that figured out, you can make a hole stencil based on the positions and the holes of the knobs or pulls. This is especially helpful if you have pulls where more than one knob needs to be drilled to install each one.

Use your cardboard for this. Take one pull and place it on the cardboard where it will be touching the surface of the cabinet. Mark right next to the side of the pull with the pencil. Poke a hole through the carboard where you marked with the pencil. Use these holes as a stencil for marking the cabinets where you will be drilling.

Amerock Allison Knob in Antique Brass

Make a Pilot Hole

Carefully make a pilot hole on the pencil marks with a drill bit that is slightly smaller than the one you will actually be using to drill the holes for the screws. A pilot hole doesn't go all the way through, but only gets the hole started, so the drill doesn't damage the wood.

Make Sure the Drill Bit is the Right Size

Use a drill bit that is the same size as the screws. Too big will cause the knobs or pulls to be too loose, and too small will end up splitting the cabinet wood from the holes you drilled.